Specs ASTM B Alloy OFE OFHC Copper Round Rod. View More · Alloy Copper Rectangle Square Edge. ASTM B – Free download as PDF File .pdf), Text File .txt) or read online for free. C Round OFE SH Copper Products Rod. H04 (hard). 12 Foot Mill Lengths. ASTM B, ASTM F Diameter. (Inches). Diameter. Tolerance. Pounds.
|Published (Last):||10 October 2013|
|PDF File Size:||20.40 Mb|
|ePub File Size:||18.4 Mb|
|Price:||Free* [*Free Regsitration Required]|
Preparation for Delivery S4. Over 4  to 12  incl. When tolerances are speci? Expressed to the nearest 1? The values stated in each system are not exact equivalents; therefore, each system shall be used independently of the other. F Special agreement shall be made aetm the manufacturer or supplier and the purchaser.
Last previous edition approved in as B — This abstract is a brief summary of the referenced standard.
The copper value is exclusive of Ag. This term means that a wire 1 m in length and weighing 1 g would have a resistance of 0. Originally approved in ASTM International takes no position respecting the validity of any patent rights asserted in connection with any item mentioned in this standard.
C, C, C, C The compositions of these alloys are equivalent to C plus the intentional addition of silver. Over 2 to 3 [50 to 75] incl. Combining 1 This speci?
Impurity maximums in ppm of C shall be: Measure the maximum depth of arc to the nearest 1? Within the text, the SI units are shown in brackets. Mechanical Property Requirements Products shall be sampled and prepared, then tested accordingly to examine their conformance to dimensional mass, diameter, thickness, width, shape, specified and stock lengths, straightness, edge contour, and radius of edges or cornersmechanical tensile, yield and bend strengths, elongation, Rockwell hardness, and embrittlementelectrical resistivity, and chemical composition requirements.
This standard is subject to revision at any time by the responsible technical committee and must be reviewed every?
ASTM B187 Grade C10200 H04 bar
This standard has been approved for use by agencies of the Department of Defense. A B Width times thickness, disregarding any rounded corner or edges. The deviation from absolute straightness of any longitudinal surface or edge shall not exceed the limitations prescribed in Table Short lengths b817 be included as prescribed in Table 9.
Except as otherwise speci? Sawed deburred bar to use Table 5 and Table 7.
Specs ASTM B187
C Light-straightening bb187 is permitted. Individual reprints single or multiple copies of this standard may be obtained by contacting ASTM at the above address or at phonefaxor service astm.
Current edition approved Apr. Over 2  to 33  3  incl. Your comments are invited either for revision of this standard or for additional standards and should be addressed to ASTM International Headquarters. All sizes 28  Rod: E C, C, and C are oxygen-free coppers with the addition of a speci? Other coppers may be used upon agreement between supplier and purchaserer.
The approximate Rockwell hardness values for the speci?
ASTM B – 00 Standard Specification for Copper Bar, Bus Bar, Rod, and Shapes
It is also equivalent, for example, to 1. This is equivalent to a resistivity value of C NOTE 1—The arc shall not necessarily be tangent at points, A, but shall be substantially symmetrical with the axis of the product, and the product shall be commercially free from sharp, rough, or projecting edges.
Over 1 awtm to 35  2  incl. A superscript epsilon e indicates an editorial change since the last revision or reapproval.